ep

January 20, 2021

Power UNITS FOR LIFT TABLE 1
Common Description
This electrical power unit is created exclusively for your tiny lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This energy unit has been broadly utilised inside the marketplace of logistic units including minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is managed from the solenoid valve using the speed managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
General Description
This energy unit is developed exclusively for that medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve plus the speed managed by the adjustable needle valve. When the lift rises to a high positoin, but the energy provide is cut, the lowering movement is controlled from the guide override function.
Energy UNITS FOR LIFT TABLE three
Common Description
This power unit is designed solely for that substantial lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve along with the speed controlled by a stress compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE four
General Description
This energy unit is developed exclusively to the substantial lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve and also the pace managed from the adjustable needle valve. When the lift rises to a substantial positoin, but the power supply is minimize, the reducing motion is managed from the manual override perform.
Distinctive Notes
one. This power unit is of S3 duty cycle, which can only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean all of the hydraulic components concerned prior to set up of the electrical power unit.
3. Viscosity of the oil shoud be 15~46 cst,which ought to also be clean and absolutely free of impurities.N46 hydraulic oil is encouraged.
4. Oil altering is needed following the preliminary one hundred operation hours,afterwards the moment every 3000 hours.
5. The power unit proven is intended to be mounted vertically.